My Automatic had a large aftermarket cooler it was connected to. So I don't know the original connections to TT radiator. As the FSM doesn't...
I'm slowly putting an engine back together. The right hand side turbo is on the table. Took off the coolant lines to clear out the...
Changing turbo headers out, Had to remove water galleries to reach nut on header flange. The Water galleries at the banjo fittings on the Turbo...
The EGR pipe on the turbo manifold itself. When applied heat, anti-seize spray and hammered on 21mm spanner (22mm too much flop) can't remove...
The other topics don't really say and any pictures showing mirrors are missing. If laid side by side: How do you know the difference between ADM...
My JDM 2+2 has a few things missing, which are needed/wanted As the car has aftermarket mirrors not to my taste, I'm Looking for LH & RH...
Wondering if anyone would know the reasoning behind earthing the white wire that feeds from the fuel pump to the FPCU just before the plug of...
I bought a 2+2 recently and it is missing bits under the boot carpet. I would like a picture of a complete boot layout: of what's meant to be when...
Looking for a 2+0 fuel filler neck. As one that I was going to buy:specifically requested, was sold out from underneath me as it were.(down side...
Replacing the dead bushing that holds the 2 steering shafts in the engine bay. I noticed that I had side movement in the steering column while...
While I have a 2-seater with functioning washers. I do have a 2 finger size hole were water has collected and rusted out. To stop/minimize...
Liquefied air filter rubber seals When I bought my Z32 back in 2016, I changed it to pod filter as to be more affordable option than replacing...
The joys of having aftermarket suspension, and going back to stock. I need the top plates that hold the standard strut piston in place.
Looking for Right-Hand pillar trim for my t-top car.
My drivers interior door cable linkage has been broken and linkage mount on the door drilled so cable not aligned. Possibly the cause for door...
For anyone that has standard ride height or someone that Knows 100% What is the Standard ride height from wheel center to peak of wheel arch? I...
I bought a Z32 recently that has an aftermarket ECU. It also has the D585 LS2 truck coil conversion. Looking at the wiring; they cut the IGN...
I'm Looking for a set of (Or at least the LH side) 2+0 T-tops that are free of rust. Idealistically red, but any colour would do. I'm in...
On my car (2+0) the rear glass sits below the line of the hatch. Is it meant to be flush with the hatch? Or is it a design flaw with the Z32 As...
I've taken my car Jax tyres a number of times. After each wheel alignment, they note that the Rear right toe is at it's maximum adjustment. I...
Separate names with a comma.