Have a set of 2+2 floor mats, overall good shape, regular wear and tear. $120. Nismo rear knuckle/RUCA/rear traction arm bushes x 4. 8 required...
Brand new SPL toe rods, brand new Nismo toe rod bushes for the knuckle and used UAS conversion brackets. SPL arms are kinked for extra subframe...
[ATTACH] [ATTACH] [ATTACH] - Rare factory option Altai light up tail light panel. Illuminating strip no longer functional but can be replaced....
Got some stuff I need to advertise but haven't had a moment to do it properly and take photos. The easy ones I have going right now are in the...
As the title says. Great condition. $280. Will freight, offers considered.
Fitting up some Bosch EV14 injectors to my Cima lower plenum. Never needed to custom fit injectors before, can someone point me in the right...
As above, made by Queensland Driveshafts. Good shape. Offers welcome, will freight but preference given to local pickup at Ryde. $350, offers...
Thinking of chucking a fuel cell into the back of the zed. I shifted the factory fuel tank upwards to clear the diffuser and in doing so removed...
Set of never used DBA 5000 two piece rotors. Had them sitting around for a few years waiting to go on my project but were never fitted. Had them...
Crap music crap fenders very cool car npGbPu4u4-s - A
So my calipers didn't come with any shims. Who here has experience with shimless calipers? How did you find any noise issues? - A
6 puck single plate clutch, pressure plate and flywheel IIRC 500 HP rated. It has 2,000 k's on it and was only just broken in when my motor blew....
As title states, harder to find high reading speedo for series 2 cars. Has one vertical plug and two horizontal. Overall good shape, 242k on...
Trying to do some rough calculations to see if this whole single plenum thing will work or if it'll just be a downgrade Using this calc:...
Thought this was pretty sweet. Did some measurements and it looks like a really really good fit for the VG if adapted to the lower plenum, and...
Just bought this to use as a harness bar. Unfortunately I then found out that the eyelets in my VeilSide seats are quite a bit below my shoulder...
Found this on Facebook and thought it was pretty sweet. Don't think it's really necessary if you replace the stud when you should but it's a cool...
I want to do an order of chassis bracing from the above mob, anyone want to join in? Obviously Sydney or any savings will be lost. -A
Lamco sandwich plate, two fittings different sizes. Used, comes with o-ring. $40 [IMG] [IMG] GReddy oil thermostat, $80, not sure if I still...
I want to knock up a harness bar but am not sure what to make it out of. Steel is strong but heavy so I'd prefer Aluminium, or at worst...
Separate names with a comma.