View under the car, ignore the jacked up rad support : - (
Nice and easy without spilling oil everywhere!
The reason I did this was wanting to...
With front bar installed.
Before I post the BOV I should provide some context to the cooler setup.
My original stock cooler was super beat up, and I wanted to run a bigger...
Went for a drive in a car with turbo smart BOV and was hooked.
Got the kit from @rob260, went in easy. I already had replaced the stock bov with...
Hub full assembled;
Installed in the car. Also replaced all the bolts. Need to tidy up a few more things like the calipers but thats a...
I recently replaced a rear wheel bearing, and noticed the knuckle bushings were bad.
Naturally replacing them turned into a huge project.
I am after the stock shifter assembly that bolts into the manual gearbox.
Located sydney happy to pay post.
I've checked, I am not sure exactly what is occuring with the FPCU, but it seems to have been bypassed and the pump is getting 12v. Next step is...
Ahh I had them flow tested and cleaned I think they were all good.
Issue ended up being the timing 180* degrees out. Got it started!.
More to add
-Purchased new engine loom / trans loom due to the old one having the consistency of cheese.
-Bde oil filter relocation with...
Found some more photos of the ening assembly;
Pre and post the cleaning of the smoo off the turbos.
I ended up getting a parts washer for this...
Post painting, regasketing etc. Should of painted the balancer but oh well.
Had recently done a major timing service on this motor.
Test fitting in the bay to check clearance etc.
Don't worry the valve covers and plenum are getting painted later.
Decided to replace the water lines with an braided lines from @rob260
Mocking them up;
One of the finished sides ;
Thought id do an update;
Faced with a large amount of issues I was trouble shooting - I thought it was best to pull the motor.
You'd be best to fit a late model usa spec with airbag I think
Currently stalling out after throttle. Thinking of bringing the smoke tester home from work as the next fix.
Still grinding on this thing.
Had the car back together.
Installed a LINK ecu and tried to get it started.
Followed the guide and couldn't even...
Also found another photo of the engine mount activities. This was at 11pm in pouring rain. I wish I had an garage...
Separate names with a comma.