Book doesn't seem to show it. I also haven't taken the scuttle trim from around to wipers to properly have a look. So the only advice I could...
I'm still curious of the end exhaust note.
Thanks for the info My array of adjustable spanners (what ever they actually called) all had too much flop in their movable head and couldn't be...
Engine is out of car. I removed the turbo from the manifold, placed the damaged EGR 22mm head in the vice and rotated the manifold. So it's...
The EGR pipe on the turbo manifold itself. When applied heat, anti-seize spray and hammered on 21mm spanner (22mm too much flop) can't remove...
Will you post a vid/audio file of the end sound result?
Can't help with Auto electricians for Brisbane... or anywhere really. Have you checked the boot's switch wiring? As it powers the door light...
Still looking for cargo blind and both L& R outer door trims
Clarification: I have JDM car I bought possible ADM mirrors. Turns out to be JDM (which is fine) as they power fold. The TT net shows outside...
Interesting read. Now the question is; Is the design of the American and Australian mirrors mounting points the same? As the outboard...
Thanks, but I have JDM, I just wanted to see ADM difference. As I bought a pair of mirrors that were possibly ADM. However in cleaning...
The other topics don't really say and any pictures showing mirrors are missing. If laid side by side: How do you know the difference between ADM...
Just pulled out the collection of clusters I have. Looking at the later one, they do share the soldered link that goes to the ground on the top...
Ok looking at the FSMs I have. 1992 version shows Type A and Type B. It classes mine as Type B and yours as Type A Picture of early dash...
Whilst the oil signal goes to the pressure sender unit, and the Tacho goes to ECU, the cluster you shown is the later model. My FSM is for the...
When the gauge cluster was plugged in and engine running, did you wiggle the wires to the plug to see if the gauges jumped back to life? --- Are...
With gearbox removal: Unless you drain out the transmission fluid first, you would need a transmission's driveshaft plug/stopper....
I know late model clusters have a plug change, cant remember what specifically. But the gauges themselves can swap out; as that is what I did...
Pull the cluster out. Check the circuit board on the cluster for damage. If OK, You might have a pinched/partly broken wire going to the...
They all share the same power and ground, just signal wires go their own way. Oil (Y/W wire) and Tacho (Y/R wire) signal wires are above and...
Separate names with a comma.
