The stock filters are tricky to replace but certainly not impossible. Have you got your old filters there to compare if they are different?
Definitely not suggesting to go out and buy a set. Surely you have met some other enthusiasts who would be willing help out?
Can't get yourself another set of coils to try?
Just need some clarification. Do you mean it was running fine and then after one hard acceleration it now is idling high? I would be looking for...
Standard RPM Targets are 750 RPM Auto (P/N) and 700 RPM Manual. Depending on mods it is sometimes necessary to raise this setting in the program...
In Conzult you can see in the image below in the bottom RHS pane the first variable says CLSD THL/POS. It will have a green arrow next to it when...
When you say the timing is fluctuating between 15 and 25 (I'm assuming this is at idle), I would be paying attention to the closed TPS signal (not...
I bought a HAPP 20T Press.
More stock just arrived and the first 2 sold will be $270 each delivered when you mention you saw the add here :)
Guaranteed cheapest in OZ!
12th February 2017, Gates Open 7:30AM
Earnshaw State College
Corner of Earnshaw and Tufnell Roads
I'm running BKR6E at .8mm gap with 544HP at 24PSI.
$4.50 plugs FTW!!!!
Read the OP. He wanted to know if a Nistune board with TT Maps would work on an N/A ECU.
Yes, bought a front fender from Geoff years ago.
How many split bores have you seen with these blocks? My 2 cents worth is you were just plain unlucky. Fatigued could have been a contributor...
Ztoy's is neither a Slicktop or T56.
Ztoy on the GC too, running Z32 5 Speed.
Didn't touch it. I used to use it as a temp exchange unit while I did a PROM extract and socket of the PCB.
Shouldn't be an issue. I've used a TT Chip in an NA ECU with no problems.
Video is Private :(
Separate names with a comma.