Fronts will fit fine- long as offset is around +30-+35
245/40 will also fit fine
245/35 will work too
Rear will fit and hold a 255 very comfortably
17x9+30 (33GTR wheels)
With a 275/40/17 MT ET street
These almost look like G660’s
I was tossing up the 40’s- are their sale still on ?
Jon David advertised one on FB if I’m not mistaken (zhookup)
The usual that apparently they can corrode and don’t like the moisture that ethanol/similar fuels can produce.
I noticed the custom head studs-...
Wow- I knew you were getting some interesting bits and pieces.
I like everything apart from the L19’s.
The question that everyone will want to...
Some things are happening
Wow!! I like
Sadly I don’t think anyone with a Z platform would have tried this.
However, launch control will still build enough boost to get...
Tempted to separate gears?
Do you have $4000 to spend or make 800rwhp?
The Americans RAVE about the “high 5” clutch and a few of them are running high 10’s low 11’s on it....
I’m unsure where I resorted to a personal insult -
If I directly said “you’re an idiot” then yes.
I did allude to difficulty understanding your...
Well the OP can take your advice (which I can’t even break down properly so I’m guessing English isn’t your first language)
And than be very...
I’m quite aware of nistunes development as it was out last year.
For the power the OP is intending or targeting 740cc IS way to small flex fuel...
Give me a long enough runway and I’ll swap in a 3.3 armada diff and rev to 8500
Assuming I don’t disintegrate in the process
Month is chump change mate, try 12 months
Few issues above that may bite you
The reason you haven’t found any information on it is because there’s only 1 car to my knowledge that’s done a 3076 set up and that was after a...
Not sure what actuators you have but I’d strongly check that- internal actuators I don’t think even go up to 23psi on spring pressure.
I may not be the best example On how this manifold performs because of other accompanying work but I may well be the first with the manifold...
Separate names with a comma.