Basically i was going to do a twin TD05 kit using Evo 8 Td05's, but have since decided against it. This is an EVO 8 RS spec TD05. The designation is TD05HRA 16g6 9.8T, which basically means it has the titanium alloy comp wheel, and the smaller 9.8cm2 housing. Spools around 500rpm faster then a non Ti unit. Comes with actuator but no lines. Very little lateral shaft play, no axial play. Would suit somebody looking to build a TD05 kit on the cheap as Stock EVO turbos are pretty common. Rated at around 360hp Looking for $350 PM me Matt
just a bit of trivia - this is the same turbo dad runs on his VOLVO 740 pretty sure he paid not far off that for a single though, gl with sale!
Good. But to be honest I'm surprised you can fit them in ok. The evo turbo's have a massive dual scroll inlet on the turbine.
They can be fitted, there is a vid on youtube with a 700+ rwhp Z (td06) and a few vids of td05 powered Z's aswell.
Well the setup im going to copy the guy has used a T04 and T70/T3, is this much bigger then any of these? Americans have used GT35's for the same job.
I mean physical size, if it's something between a t70 and a gt35 then sweet but if its much bigger then space is too much of an issue