that's funny. the pic I chose was the Jeep trailhawk. I'mhoping to pick one up in a few weeks. alright cherubs. ive organised scanning...
did everyone whos taken it for a test has just told me that's pretty much what to expect from a TT so what? I'm to expect a slow piece of...
Hi Pmac they do look clean, but is there any way to test just how well they are performing? Looks like i'm in the market for a new set of...
The Z wisperer After 2 years of putting up with one of the poorest running twin turbos in Aus, I took the Z to a mechanic suggested to me by a...
Hey, how is the software development going for something like this? those who are into that side of things? I haven't bothered trying to...
interesting that probably would have sucked through about the same amount though (500ml) but, I didnt have the vac line sitting 100% in the...
have you ever considered that perhaps this cooler is just too epic for most z applications? most Z's might struggle to cope with its Epicness....
if it helps at all... I used this image to break down what goes where in terms of the harness. you just have to remember you have 1 02...
could you tell me how quickly you put the water through the vac line? and what rpm i was 500ml over the space of about a minute at 2200rpm...
yup, I think what your seeing is quite normal. its not uncommon... give the liquid a smell and I bet it doesnt have one. meaning its probably...
I read. maybe post up a vid to youtube and link it here. easiest way to listen to whats going on. have you done the balance test to see if all...
I wouldn't worry about it.... if its only at idle then its probably nothing. after I had my Z sitting for 5 weeks doing the engine bay, I had a...
Trust me, I know! this part is just for a bit of fun :) like an adult, 3d colouring book of Z's... I had such a terrible week last week trying...
found this [IMG] I reckon the height and angle of that screen would have been impossible to read through glare.. I can't even read my temp...
Lol... KK the sketchup model probably won't be high enough quality for a 3ds max model. but you can use the original .obj model and import into...
Separate names with a comma.