I believe the lock-up circuit is powered by the TCU and grounded inside the transmission at the solenoid, so I don't think a ground wire in the...
It seems like the problem would be either with the TCU or the lock-up solenoid in the transmission. Check if the TCU turns off the voltage to the...
What are you using to install the seals? A tool with a counter-bore (see attached) should be used to drive them onto the guides... the...
1.380" OD, 0.788" ID, 0.512" thick
110° ATDC for the intake is surprising to me, the OE manual cam is 125° ATDC while the OE automatic cam is 120°. So the JUN 272 would be advanced...
You already have BDE VTC gears - the 12 screws around the center hub are a signature of my product, and you will not be able to spin the rear seal...
I don't believe the fuel system will hold pressure with the damper removed... I know mine doesn't. I view the damper as more of a check valve...
You could use a small mirror to look behind the VTCs before removing the timing belt to see if it appears oil is radiating outward on the back of...
What exactly is there to figure out? You're copying something that has been done for years by other people... correct? That still does not prove...
I completely agree that your crank oil mod "works" in that it still has an entry and exit that supplies oil to the rod bearing, but your claim...
I've never agreed with the logic of your VG crankshaft oiling modification, here's why: Unless you are re-drilling factory cranks (you're merely...
The two studs are used to help align the plates during assembly. First the part on the lower right bolts on the block, then the two studs are...
I always assumed those were just solid spacers, but after looking closer at a few used ones I have here, they definitely are a multi-piece part......
I quit offering ID2000s with my fuel rails because I cannot control the quality of the fuel people use with them and Z1 only lists the injectors...
One question that lingered while I was doing the flow testing was: "how much coolant flow is needed?" This would be a variable dependent upon how...
Separate names with a comma.