Z32 Which clutch is the best of these three for drag racing

Discussion in 'Technical' started by chewy, Sep 24, 2019.

Tags:
  1. chewy

    chewy Active Member

    Messages:
    2,647
    Likes Received:
    16
    Trophy Points:
    38
  2. rob260

    rob260 Moderator Staff Member

    Messages:
    13,062
    Likes Received:
    214
    Trophy Points:
    63
    Location:
    Sydney (North)
  3. MagicMike

    MagicMike Moderator Staff Member

    Messages:
    7,372
    Likes Received:
    115
    Trophy Points:
    63
    Also talk to Direct Clutch Services near Brisbane CBD. They can build you something to suit, and all their stuff is rebuildable.
     
  4. ProckyZ89

    ProckyZ89 Senior Member

    Messages:
    3,019
    Likes Received:
    15
    Trophy Points:
    38
    Do you have $4000 to spend or make 800rwhp?

    The Americans RAVE about the “high 5” clutch and a few of them are running high 10’s low 11’s on it.
    Plus it is 1/3 the cost of most of those.

    I’f however you do want to sort of future proof I’d check with robs suggestion.
    I actually was going to refer my existing twin to them to see if they can make a more “hardcore” version of it.
     
  5. chewy

    chewy Active Member

    Messages:
    2,647
    Likes Received:
    16
    Trophy Points:
    38
    I'll go to NPC to see what they have since they are just around the corner from me. I previously had one from them on the car but after going to the drags a dozen times I completely fried the clutch and flywheel. It was impressively coloured with blue and yellow heat stains. Wish I had a photo of it still but that was 15 years ago.

     
  6. Boll!

    Boll! Well-Known Member

    Messages:
    931
    Likes Received:
    23
    Trophy Points:
    48
    Hi Chewy.
    Was the above a twin plate?
    What kind of power do you have?
     
  7. chewy

    chewy Active Member

    Messages:
    2,647
    Likes Received:
    16
    Trophy Points:
    38
    It was a 4 puck single plate. At the time the car was producing only 300rwkw but this rebuild I'm aiming for about 480rwkw.

     

Share This Page