!!!!Third and FINAL round of bits you will want off 90ZTT!!!!

Discussion in 'Car Parts for Sale or Wanted' started by Martin, Jun 27, 2010.

Thread Status:
Not open for further replies.
  1. Martin

    Martin New Member

    no
     
  2. Martin

    Martin New Member

    I'll try to figure out a box big enough, i'll get back to you...
     
  3. Martin

    Martin New Member

    I do not have them
     
  4. supersonic

    supersonic New Member

    The boot trim? Ahh damn...
     
  5. Martin

    Martin New Member

    I was more referring to red turtle'es request...
     
  6. Stufarny

    Stufarny Stuart

    There was a female zed owner after a set of tail lights here on the forum just recently, in Victoria I think?

    Stu
     
  7. 300zx

    300zx New Member

    Hey, do those targa shades fit a 4-seater? If so, I'll take them. Let me know.
     
  8. Martin

    Martin New Member

    they do not :(
     
  9. Martin

    Martin New Member

    UPDATE!
    Parts that are sold
    Targa Trims
    Targa Bags
    Starter Motor
    Clutch master cylinder
    Pedders Springs
    Clutch Booster
    Tail lights
    Cruise control gear
    TTFPCU

    PARTS THAT REMAIN!
    Boot trims
    gearbox
    master cylinders
    water temp guage with sender
    targa shades
    rear brakes
    fuel pump
    clutch slave with braided lines
    shrouds
    Fans
    Dash hood

    ALL MUST GO!!! i have bought a new car and need to make room in the garage!!!
     
  10. Evil Twin

    Evil Twin Time to 'Suit Up'!

    Hi Martin, what did you get - an EVO?

    FYI - I have started rebuilding your old zed :rolleyes:

    I have rehung the drivers door, refitted my old interior and most of the missing trims, put most of the steering back in, replaced the brake master cyclinder, replaced the drivers guard and front bar, have the brakes and rotors to be replaced, will also have whole exhaust, suspension, fuel pump and a few other bits as i replace my zed parts - im leaving it brazillian at this stage, as well as refitted the Kaminari kit - I may get away with a partial respray with some luck - well the front half only.

    I havent cut out the damage yet - going to get someone to do this professionally. I have also found a 3" hole in the passenger side floor - possibly from a fork lift?

    May end up as a track car if its confirmed as twisted - bit dubious at this stage. Hopefully she may live again in some guise.;)

    I have a wanted thread for the main things I need - still may end up with an LS2 in her yet. we'll see.:)
     
  11. Martin

    Martin New Member

    awesome! i admire your determination, it will be good to see that car live again!

    and no, unfortunately my USA trip ended up slighty (no, i don't mean slightly, i mean ALOT) more expensive than i thought, so kinda ate into funds for a new car :eek: you'll laugh but i'm now a bogan! baught an immaculate VX SS commodore, of course with a 6 speed manual. I must say i am impressed with it though. for a big car it handles well! its not that heavy either, at 1.6tonnes its the same as a 2+2 auto zed! and the massive torque from the ls1 is addictive :cool:. Plan is to make it evil, looking very closely at some superchargers when i get some funds together again, at this stage it has a full exhaust and extractors, to give it a nice v8 roar :D
     
Thread Status:
Not open for further replies.

Share This Page