pre wired injectors

Discussion in 'Technical' started by mijake, Feb 2, 2008.

  1. mijake

    mijake Member

    Messages:
    311
    Likes Received:
    0
    Trophy Points:
    16
    I tried pm Zrated but his inbox is full so i might try asking people on the forum.

    Has anyone had trouble plugging in the prewired injector connectors into the injectors? There is a groove in the plastic that helps you with the direction of getting the plugs in but what i noticed was that the groove in the stock injectors is off centre and the injector connectors i got from zrated are in the centre. Is this right?


    kind regards michael
     
  2. 90TTZ

    90TTZ Back From The Dead

    Messages:
    4,608
    Likes Received:
    43
    Trophy Points:
    48
    That's correct. You have 2 choices, either use a dremel and make a new slot in the plug or the easier and better way is to get a small chisel or screwdriver and knock the lug off the injector itself. There is really no need for a locating key (lug) as the wires and be put on either way. It does not matter for the injectors.
     

Share This Page