Fuel Injector cleaning

Discussion in 'Technical' started by geron, Nov 1, 2017.

  1. geron

    geron National Petroleum Equipm

    Messages:
    510
    Likes Received:
    13
    Trophy Points:
    18
    Hey guys,
    I have a set of 555 injectors that need to be checked for flow, spray pattern and clean as necessary.
    They were purchased from ebay about a year ago and they are supposed to be cleaned and all, however, before they are installed, I would like to verify that they are 100% good to go.
    Does anyone on here do this?

    Thanks
    Peter
     
  2. Boorkus

    Boorkus Member

    Messages:
    50
    Likes Received:
    2
    Trophy Points:
    8
    I bought some newly reconditioned 650CC injectors off eBay a while ago. Just as a retard check, I took them to a local fuel injector shop (United Fuel Injection) and got them to flow test them and let me know if any of them are out of spec. Got them back next day with all of them flowing well and perfectly within spec.
    Just make sure you get a full new set of O rings - they are only useable once, and must be replaced after the injector has been inserted into a rail.
     
  3. MAX

    MAX Ex Zedder

    Messages:
    1,936
    Likes Received:
    3
    Trophy Points:
    38
  4. geron

    geron National Petroleum Equipm

    Messages:
    510
    Likes Received:
    13
    Trophy Points:
    18
    Thank you Gents. I'm in Gosford, NSW. It's not a problem, I can send them anywhere interstate.
    The seller said these were flow matched, cleaned and ready to go. Just by me looking at them I believe they already have new O-rings. Having said that, they will have to be inspected and get a second opinion prior to installation.

    Thank you for the suggestions!!
     

Share This Page