VIC 300zx z32 Non-Turbo Auto Transmission Computer

Discussion in 'Car Parts for Sale or Wanted' started by gregzilla, May 3, 2019.

  1. gregzilla

    gregzilla Member

    Messages:
    49
    Likes Received:
    13
    Trophy Points:
    8
    Location:
    Melbourne
    Hi all,

    I'm wanting to replace my auto transmission computer in my '89 non turbo 2+0 and also I need the power/hold switch next to the t-bar

    The details I have are as follows...

    31036 43P00 | A64-000 M43 | 9Y13

    Let me know cost and postage to Dandenong. Victoria 3175
     
  2. Martin Williams

    Martin Williams Well-Known Member

    Messages:
    1,024
    Likes Received:
    31
    Trophy Points:
    48
    I will check and get back to you
     
  3. Martin Williams

    Martin Williams Well-Known Member

    Messages:
    1,024
    Likes Received:
    31
    Trophy Points:
    48
    The details on the A/T computer that I have has the following details;-

    31036 38P00| A64-000 M47| 9Y06. This came out of a 1991 Australian delivered non turbo 2+2. Did not have a power/hold switch.
     
  4. Doug

    Doug New Member

    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    1
    Hi, I've got a problem with my power hold switch but I'm not sure the real problem is the transmission ECU. I found you by looking for 31036 43p00 TCU. Even with it disconnected, the hold light works but not the power light any more and the tranny went into hold mode. I'm just looking for information that may help. I've got an original workshop electrical manual ( A service agents manual I think) coming over from the USA for the 1990 300zx. Non of the manuals I have on computer even show this switch or where the wiring goes. Any help, particularly with what happened to you and the fix would be a great help Regards
    Doug
     

Share This Page