As some may know my Aus Spec was stolen and recovered a while ago, the insurance company wrote it iff as it was missing for a full week and it's...
I'm getting a few small bits and pieces from CZP in the next week or 2, anyone want anything and interested in combining shipping?
Is there a clip or locking pin or something? Service Manual says to remove bolt then use steering wheel pulley, tried that and it's taking a...
Does anyone know if early and late model brake master cylinders are interchangeable? I'm looking at putting a late model non ABS master in my '91...
Great trip and well organized, the hotrod museum has some absolutely incredible stuff there, especially for anyone with any interest in salt lake...
I've got an AFM for sale for $90 and also still got quite a few little bits and bobs from the slicktop I've striped out, quite a few aircon bits...
If anyone is looking at a Vq30DET this looks like a good place to start, has gearbox adaptor and low intake manifold as the VQ is rather tall....
Is 8mm ID EFI line close enough or do I need to find 7.5mm exactly? I'm leaning towards trying to find 7.5mm unless anyone can tell me for sure...
What, if any, issues am I likely to run into with wasted spark on my NA track car? I'm tossing up ideas for an ECU for my NA track car, the 2...
Don't know if anyone is interested, it seems a bit rough but it's very cheap for a 97 Here.
I'm after a set of clutch bolts and would rather just head down to the bolt shop rather than ship in 'official' ones from the US. Does anyone...
I'm looking into getting my track car caged while I've got it stripped, Ideally I'd like something reasonably minimal but still incorporating the...
How on earth do I get the outer tie rods off the inner ones? There is a 22mm hex bit on the outer rod and the inner one has slightly flattened...
I'm looking at freeing up some space and cutting down on wiring complexity by getting rid of all the fancy idle stuff on the back of the plenum on...
I'm thinking of getting the two end pieces and getting a 1 piece braided clutch line straight from the master to slave cylinder made up rather...
Anything wierd about them? Other than the obvious funny shape to fit the locking pin through I mean. For some reason I can't for the life of me...
Just saw a black z32 on it, lots and lots of great cars and roads. Worth a look.
Not sure if this has been posted before or not but it's new to me so may be new to others too: kXkaVUuKQqs
Lost of people coming up with weird and dodgy schemes to import 2000 spec Zeds so here's one that is not weird or dodgy, just rather rare....
Does anyone have information on downforce and drag for a Zed with a factory spoiler vs brazillian? Just working out which way I want to go with...
Separate names with a comma.