Was driving back from a job at work and noticed a weird buzzing noise coming from the boot. I thought it was the fuel pump until I noticed the ABS...
My clutch pivot ball broke a while back and I'm having a bit of trouble finding a replacement. Thinking they would all be the same I ordered a...
Hi guys, My clutch pivot ball snapped a while back and I've finally got around to replacing it, but am having trouble getting the snapped off...
Hi all. Thought I'd post an update on how I've been going since the rebuild. As I've just recently completed my run in procedure. Actually it's...
Literally.:eek: Geeze, you don't open the bonnet for a week and the little buggers think that gives them a license to move in. This is what I...
:bash::bash: :bash: :mad: That is all. Just needed to vent.
I did a road dyno on the Zed the other day using DatalogDyno and got a result of 237.7RWKW and 385.2NM @ 6118rpm (that's as high as I revved it)....
:D After over a year of blood, sweet tears and empty bank accounts my Zed is finally back on the road.:thumbup: Just to bring you all up...
Here's the situation, I have Turbosmart Dual stage boost controller (not new, just hooking it back up after rebuild). I've hooked it up as per the...
After some opinions on what oil I should use to run in my TT. Has had a full rebuild with forged internals. Also some advice on first start up...
Attach the lines to the oil cooler first!:bash: In particular the one that attaches to the oil filter bracket. Biggest PITA job I've done so...
Well, I was working on the Zed on Sunday (expect an extensive report in a week or two) and was in under the wheel, so decided to rub the grime of...
I seem to be missing some of my trans bolts, the ones that connect the belhousing to the block (Manual TT), I think there's supposed to be 10 (or...
Well, like the idiot I am I've managed to break a couple of the little plastic, um, things (sorry don't know what they're called see pic) off the...
Hi all I'm about to rebuild my lifters, as per the tech article http://www.twinturbo.net/net/viewmsg.aspx?forum=technical&msg_id=917346...
I was playing around with my I pistons (WiseCo) and rods (Scat) the other day and noticed the the gudgeon pin was a very tight fit through the...
Ok so my zeds been parked away in my dads shed for 6 months with no engine. I also have a lot of the interior stripped out as well including the...
Another one for the engine guru's out there.:D What's the go with this? I've been reading around, and noticed a lot of people here and on...
Well, I finally got my gear back from the machinist, so am just about ready to jump in the deep end and attempt to bolt all back together.:eek: :D...
Does anyone know if these are good rods? I wanted to get Eagle rods but nobody seems to have them in stock at the moment ANYWHERE. Caz can get...
Separate names with a comma.