this is what happened on my Zed...:(:( but what will cause this problem? [IMG] [IMG] [IMG] [IMG] [IMG]
I am planning to put GT2560r on my new engine, but not sure can stock internal could handle around 400-450rwhp ( 98 pump fuel ) with these turbo....
BTW, will JDM 97+ engine have VTC on it?
The motor is from Japan ( mine Zed also JDM spec ) I am thinking of around 400-500rwhp (with 98 octane fuel) and my Zed would be my daily drive...
I pull the engine out and find that main cap broken and destroy my engine. At the time it blown out, I was half throttling around 3k rev from 1st...
I changed the starter motor to brand new unit when I find this noise. but sometime still get that noise. so.... I thing the last I should change...
I can't find anywhere to buy a F1 racing clutch online ><! but ebay had a lot of "FX" racing clutch, is that the same brand?
Actually I'm with my Zed in HK at this moment. I need to find somewhere able to ship the clutch to HK, and I think I need to replace my flywheel...
what about XTreme Heavy Duty Clutch Kit? Their website didn't have any toque allowable for that clutch.:confused:
Hi Everyone, My Zed is running stock turbo + nistune boost to 17psi. but the stock clutch started slip at 3rd or 4th gear around 3300rpm when I...
yea~ finally, I did regap the plug to 0.8 and no misfire anymore. :p I am now running 17psi for my Zed with AFR 11.8 but I find a very strange...
I did replace the fuel filter last year... So.. I don't think is the fuel filter problem. and yea... I used WBO2 AFR number rather then the one in...
I am running factory 370cc injector, so the K value is 288. The lean out seem start from left bank first. but check with the logs. I think it...
Wait... If my Zed got ignition problem... Fuel didn't burn at all. All Oxygen still remain in Cyl. And go thur AFR with exhaust gas. Will it be...
one more question, if I put Walbro E85 400 litre ph Fuel Pump in tank. Do I need to bypass Fuel Pump control unit? or bypass relay? or just...
After the AFR and timing tuning, I need help... My Zed seem normal when I do the waste gate duty cycle ( up to around 8.9psi, AFR sitting at...
Spent a night for tuning, I lean the fuel to 11.8 when it full load. :zlove: [IMG] will try to give her some boost these few days. :D
I copy someone timing map like this. [IMG] I lose some high-end power. but gain a bit power at the low-end because this map advanced some timing...
I changed to aftermarket UD pulley. Ralcon RZ one, before I get it on my Zed, I check the timing mark is correct. =) let me try with the timing...
I did put the WBO2 in stock NB sensor location with innovate O2 heat sink. I don't really know why the Japanese ECU have such these aggressive...
Separate names with a comma.