Why do you need a filter? Its a steel screen. Take it out, wash the crap out of it and refit...
If its been machined a "FEW" times. Its time to get a new one. As they get thinner the clutch pedal will fall towards the floor until there is no...
After all this and your connections with JUN, Where's the stroker kit for the bottom end?
Someone has jacked it up under the lower radiator cross member and bent it. That pushes the bonnet latch upward and causes your issue. You have...
Most stock Z32's will still be registering fuel pressure around 30 PSI even after sitting all night.
This is really common and is easy to fix. It happens because over its life time wheel alignment guys take off the steering wheel to set it to the...
They all do that. It also the place that rusts out in the hatch first
The less you disturb the less to fault find when you finish. That's why you don't pull the engine if its running OK..
Yes you can do it, and yes I have done it. Suspend the engine off the shocker towers. Pull The steering rack, cross member, Gear box support...
No substitute for fixing it properly, Get a Panel beater to rack it and get it straight... This was my car before and after it was fixed. It was...
THIS, in fact I would go and buy and old engine that has a buggered block and use the number off that..... When you get a block skimmed about half...
Yeah and pigs may fly..........
I always used Kneadit to fix this problem mate. Never had one leak again........ Twist and mix the stuff up. clean all the old shit off the...
This alone tells me he hasn't a clue. One of the wires on the coil pack connector should have 12v on it continually. If it isnt there THAT IS THE...
You where always likely to have blow by with the stock actuators at 16 PSI, They are not quite good enough even when new.
Eventually you will wear the pedal pivot hole oval with associated slop being horrid for feel. As well as being heavy as crap to use. Replace...
Weld up and redrill the lower arm holes in the cross member so they are 15mm outward from their initial position. That should give you approx 3...
Correct, The caster changes as the wheel moves up and down due to them being "radius rods", You really do need the rubber inserts as there is sone...
These are the only aftermarket tension rods you should be fitting....
Not at all...
Separate names with a comma.
