Well if it’s any consolation mate , I had thoughts about parting with mine yesterday after smelling trans fluid when I lifted the garage door. A...
http://www.twinturbo.net/nissan/300zx/forums/main/view/1106786/Some-info-for-DIYer-gauge-cluster-repair.html...
Congratulations on your purchase, lovely looking (original) car. But then i may be a bit biased, I've got one the same only an auto. Just on the...
You may be aware of this already, but check also the two flexible fuel lines just below the battery tray. Some people are unaware they are there...
Glad you finally nailed it ! Was about to suggest your battery voltage might be a bit low to switch the ECU. Enjoy the long weekend :)
Article here.... http://www.twinturbo.net/nissan/300zx/forums/main/view/1137236/Nissan-ignition-switch-fix-and-keyed-barrel-replacement.html...
The answer in this old post by 'Dino' would suggest it's 92kg including torque converter. http://www.aus300zx.com/forum/showthread.php?t=309403...
Just an edit to that, one of the concept zed covers is no longer available . This one...
This might be what you're looking for. Sadly no part number listed but gives you somewhere to order from if it suits. Watch for difference between...
I dread to think what these are worth Rob but it looks the Bees Neez. 20 ton and built in oz. Called the Workshop Mate and based in Putney...
The trims are relatively easy to remove as per this guide http://www.300zx-twinturbo.com/tech/trim/doortrim.htm I'm not a trimmer but you could...
A Happy and Safe Christmas to you all.. Hope everyone on here has a wonderful day with family and friends. This came to me a little while ago...
Yep, Zed Fever........no known cure !:D
Second hand ones from two members $50 and $200 here http://www.aus300zx.com/forum/showthread.php?t=336070&highlight=AFM and here...
Bosch replacement from Repco P/N F00E000202. Not sure if you'll need a plug, but here's the P/N AFM Plug #1 287 013 004. The cheapest I've seen...
I just discovered this nice little youtube clip on testing a series 2 PTU. Jump to about 6 mins in for typical resistance values between the...
Have found quite a few different tyres in the last week I'm OK with the numbers - not sure what the D and R are R maybe Radial D anyone I...
I too noticed how hard the OEM hoses were so opted for Goodyear Hi Miler hose, used extensively in the trucking industry. This was before the...
I.D. is 32mm or 1.25 inch. Not sure of the length, I just bought a length of straight rad. hose and cut it to suit. I used Loctite Copper Max...
Separate names with a comma.