Thanks for the detailed response SRB-2NV. It helps but I still feel very newb on the matter lol. Another thing I am contemplating buying is the...
Thanks Rob. I've noticed the turbo I have my eye on from Conceptz (G7 GT 2860r) doesn't have an option for a 2.5" inlet. I also haven't seen...
Hi everyone, Another question for the community here. Does 2.5" intake piping actually provide a performance benefit? I understand larger...
Thanks ProckyZ89. My tuner managed to squeeze out 420 hp on a Mustang dyno with all my above stated mods yet still stock turbos so I was thinking...
This thread has given me some more to think about: https://forums.nicoclub.com/injector-sizing-for-e85-t427891.html While the OP there isn't...
Hi everyone. It's been a while since I've posted in here (moving / building a new house / baby...) life, sigh... I am finally near a point where...
I read about this earlier in the week. Automotive engineering is strong these days but makes me wonder how long before my Z32 is just a relic...
Haha, wish I knew!
Yep yep. However anyone who knows me understands I have always really bad luck, as in the most unlucky man they have ever met. I've always said my...
Well I guess I should provide an update here. Long story short, I drove my car out of the garage 1 day before handing the keys over (closing) on...
I was a little worried about generating excessive heat from the friction between the rod and crank after noticing some blue spots on the crank....
Looking for opinions on connecting rod side clearance. I have Eagle rods with a stock crank. Eagle calls for .015mm to .040mm side clearance. My...
Just a pic of the gasket kit for those looking for pics [IMG]
New piston rings, valve guides, and valve seals from ConceptZ came in today. I dropped those off along with my block and heads at the machine...
Update: I've had an issue with oil leaking through my valve seals. I replaced all the valve seals and this issue remained so i decided the...
Well it has to be one or more electrical connections somewhere so dont give up hope, slow progress is still progress. Try looking around the...
Its likely that trying to start the car with any of the grounds not perfectly connected that your PTU has been fried (again, ask me how I know.....
Have you checked the ground that goes on the transmission bell housing? It can be a pain to get to and easily missed when putting an engine back...
These are the products I use on my electrical connectors: [ATTACH] [ATTACH]
Thanks LitlElvis. I didnt use any special tool to put the seals on. I used a deep well 10mm socket which might just be my issue since I cant say...
Separate names with a comma.