THE END Yea Im certianly going to miss mine. Caught fire at the Wanaroo Raceway. Not sure why but it was in the rear wheel arch. Thought I had put...
Hi All This is a very difficult for me to do but my car caught fire recently at Wanaroo Raceway. The shell is destroyed but thankfully the...
My steering is not heavy at all because of the explanation above re weight over the front axel. So I don't need to add any electronics to give it...
Just starting this post as general discussion to get opinions of those with actual knoweledge. I am wondering what the steering would be like if...
Hi John, I'm the guy mentioned by Rob. I'll take them. 0450737537 or gttoolsperth@gmail.com
Great to see you have rescued it from what was some absolutely shocking work done by a very dodgy shop.
I'll have some 350Z front Brembos and rotors for sale in a couple of months. These are a direct bolt on. I'm working on fabricating some brackets...
I wont bother answering next time with an attitude like that. I thought you were after ideas of what could be done but it is obvious you are...
Rears are 18 x 10 35 Tyres are 295 / 30 sit no more than 5mm outside. Fronts are 18 x 9.5 25 Tyres are 265 / 35 Flush...
For sale R33 (or 4)? Front brake calipers with dogbone brackets. Where fitted to my Z32 until l bought Brembos. Good condition, no leaks. Near new...
Not difficult at all. Really is a great car to drive now, tons of torque right through the rev range. VERY RELIABLE, it is my daily transport....
Do you still have this available?
Ok should I resurrect this thread???? Give me a thumbs up if you want the full story. Sold the car in 2016 as I was sick of dealing with all the...
I developed this system for my LS swap, fits under the dash. [ATTACH] [ATTACH] [ATTACH] [ATTACH]
So what is the difference between the NA & TT master cylinders?
Alan at Autospark evolution is you man. 300 ZX guru. https://www.facebook.com/AutosparkEvolution/
I'll take the nose panel
What offset do you have? I'm looking at getting new rims to fit a 305 rear, thinking about 40mm offset would work.
What did you do for your clutch master cyliner? where it hits the RH head?
Hi NS-Zed & Woo05H, I'm part way through mine, using an L77 6.0L with T6060. All LS accessories. Fabing all my own mounts etc. I just started a...
Separate names with a comma.