Does anyone have any pics of their oil filter sandwich plate setups showing routing of oil lines? If yes could you post them up please :) Also...
Checking a few things on the racecar this afternoon, and noticed the passenger side exhaust housing was wet with oil :( Couldn't see anywhere it...
Don't suppose anyone has a part number for a rear lower control arm ball joint boot? These don't seem to be listed anywhere as an available part,...
Looks like the forward bush on the driver side rear lower control arm is stuffed! Initially thought it was the ball joint but there is visibly...
Has anyone got any pics of how they've run the oil hoses at the filter tree when installing sandwich plates or relocation adapters? ie to the...
Anyone got access to a sheet metal bender in Sydney? I need to bend some alloy sheet 600mm wide. Just one piece, around half a dozen bends. Need...
So according to several links on twinturbo.net, and a few on here as well, the TT flywheel should have a 0.008" step up for the clutch contact...
I've had these up for sale for a while and just no interest, but they're too good to just throw out so if anyone is interested in picking them up...
So now that I'll be running E85 I plan to replace all the remaining factory rubber fuel hoses. Three of these are a sharp 90 deg, so I'm guessing...
All items pickup from Dundas Valley, Sydney, unless stated otherwise. Targas Covers and Targa bags GC $20 each set. [IMG] [IMG] [IMG] [IMG]...
If anyone is interested in any of the following before it all goes in the bin next weekend please let me know. All from 2+0 TT. Sorry pickup...
2+0 Targas free for pickup this week only or will be binned. Targa Covers and Targa bags $20 per set. Pickup only. Located Dundas Valley,...
Does anyone know of an online calculator or formula that can tell me what boost to run at a certain rpm to maintain a certain injector duty cycle?...
So again this is for the race car. I have HICAS lockout, toe adjustment of course, and adjustable upper control arms (possibly Tune Agent, they're...
I'm starting this as a separate thread not to start a discussion, just to gather actual information about what if any FUCA's people are running in...
Hi guys, I've read this thread; http://www.aus300zx.com/forum/showthread.php?t=331336 And others on the subject over the years. My race...
This is a continuation of my posts in the following thread; http://www.aus300zx.com/forum/showthread.php?t=328212 Requirement: Improve fuel...
Take the lot for $50. Pickup only. Located Dundas Valley, Sydney. Targas, Targa Covers and Targa bags GC. [IMG] [IMG] [IMG] [IMG] [IMG]...
Anyone got access to a lathe that could mount an 18" rim in Sydney? I have a set of rims that I need to have the centrebore machined out to...
The end (of the beginning) is finally in sight so I figure it's about time I started a build thread :) I've been slowly working on this project...
Separate names with a comma.