Diagnostics package: ECU Talk LCD , ecutalk USB, valve timing control tester, data logger for setting critical alarms like temps ect has 8...
Looking for an atcu pinout or someone who's wired up the atcu to an aftermarket ecu. The ecu side of things calls everything "signal wire" ffs.
Up for sale is a set of auto turbos, great condition, bugger all movement and no signs of contact, SZ 3 inch dumps and stock manifolds. [IMG]...
Im looking for opinions with regards to water/meth injection. Only really interested in first hand knowledge on the matter, like preferred...
I've just knocked my sprocket back on and was wondering what stops the rear washer from rattling around??
Im bored so whoever has an ecu that requires socketing and nistune install give me a pm or call. I only ask you front postage and send me...
I have an S2 engine i'm about to drop in the Zed, and before i do id like to find out if its from a MT or AT Zed. I cant get a hold of the...
Ive been trying to hunt down an old pic of some s1 heads cut down the guts to show the lack of material when going for a big port job off...
Thanks to a talk with Tektrader, I now realise I need to speedi sleev the front and back of my crank. I don't have verniers but figured stock...
Before i go and borrow a set of ratchet spanners from a mate is it possible to remove the thermo housing without removing the drivers side head?...
So i just popped off the sump to check the bottom end and replace seals and such and I found some brass bits floating around.:mad: Please some...
Ive got my lifters out at the moment, some are spongy some are hard. I did turn the engine over with a bar about 100 times with no oil in the...
Just doing a bit of work on my engine and I noticed that when the bolts for the exhaust cam gears are finger tight theres a bit of play, more than...
I haven't test fit a set yet but i'm assuming the splits divorced section is smaller on one pipe to clear the steering?? [IMG]
Has anybody fit one if these to our exhaust manifold?
So i probably should of started a build thread a few weeks ago but i didn't expect so much to get done in such a short time. So a coupe weeks...
So i spent most of last night trying to get the crank pulley nut off to remove a timing belt. with the engine out, no box, on a tyre. Tried...
Ive been doing a little prep work on my 95 engine and in the process noticed the S1 lower plenum ill be using has holes where the S2 plenum has...
Im looking into port matching and extrusion honing my intake. Opinions, comments, advice?
Im trying to replace the majority of gaskets on my 95 tt but im starting to feel that alot of them have to be sourced outside of Aus. If...
Separate names with a comma.