Brakes Sold
Email sent with pic's, not sure why photo's are not working, never had this problem before.
324mm Drilled and Slotted front rotors, adapters and front Calipers, rear slotted rotor and calipers, these were rebuilt & bought from forum...
Reply PM Sent
Thanks Rob and Fists So far all my research shows that the preferred option is 18's for the Zed, I already run on 18" x 8" with 35 offset but the...
Also found out that Miro 112's look similar but are designed for Big Brakes. Miro Type 112 is specially designed to fit big brake calipers. Its...
Rob I did look at your wheels but unfortunately not the look I was going for. Still trying to decide on 18's or 19's
Hi All Need some help deciding wheel size for Akebono 14" 350z brakes, Currently looking at some Miro 111. Size options are 18" x 8.5 with 35...
Thanks Thanks for the advise, picked up some Penrite 10W40. Will change it out regularly, more than likely on a time bases as it rarely gets...
Hi All So the engine was run in on the Dyno and the oil was replaced after the Dyno tuning with a cheaper quality fully synthetic oil, have done...
What about heads I am running 490HP at 18PSI, with E85 and 1150CC injectors, but heads have been ported and running 0.5mm oversize valves with...
Yes I agree, but if the R34 Rotors and Calipers fit on to the 300 zed as a combo set then the relative mounting points on the vehicles must be the...
I no the rotors are different but calipers I remember reading once that yes the rotors have a different offset but that the Calipers them self...
can some one confirm if the Z350 front Calipers are the same as the R34 GTR BNR34 Brembo Front Brake Calipers. And if so are they a direct bolt...
Glow Fuses I am in
Ceramic Coating I think it is probably a good idea as it is very hot under there. I was thinking of still making up a few sets out of the...
fuel rails Now looking at machining some up from aircraft aluminium, my brother has a section of bar i could use just need the time to machine...
Finally some positive results So finally got the engine finished and back on the dyno for some tuning, after a brief session we where running out...
Grounding From my experience when I grounded the left hand side it also engaged the right hand side, so i guess their looped.
Problem Found ROB260 operated the VTC as per Rob's advice and bingo Rattle Gone, Much thanks guys for helping solve the issue, so happy the motor...
Separate names with a comma.