that's funny. the pic I chose was the Jeep trailhawk. I'mhoping to pick one up in a few weeks. alright cherubs. ive organised scanning...
did everyone whos taken it for a test has just told me that's pretty much what to expect from a TT so what? I'm to expect a slow piece of...
Hi Pmac they do look clean, but is there any way to test just how well they are performing? Looks like i'm in the market for a new set of...
The Z wisperer After 2 years of putting up with one of the poorest running twin turbos in Aus, I took the Z to a mechanic suggested to me by a...
Hey, how is the software development going for something like this? those who are into that side of things? I haven't bothered trying to...
interesting that probably would have sucked through about the same amount though (500ml) but, I didnt have the vac line sitting 100% in the...
have you ever considered that perhaps this cooler is just too epic for most z applications? most Z's might struggle to cope with its Epicness....
if it helps at all... I used this image to break down what goes where in terms of the harness. you just have to remember you have 1 02...
could you tell me how quickly you put the water through the vac line? and what rpm i was 500ml over the space of about a minute at 2200rpm...
yup, I think what your seeing is quite normal. its not uncommon... give the liquid a smell and I bet it doesnt have one. meaning its probably...
I read. maybe post up a vid to youtube and link it here. easiest way to listen to whats going on. have you done the balance test to see if all...
I wouldn't worry about it.... if its only at idle then its probably nothing. after I had my Z sitting for 5 weeks doing the engine bay, I had a...
Trust me, I know! this part is just for a bit of fun :) like an adult, 3d colouring book of Z's... I had such a terrible week last week trying...
found this [IMG] I reckon the height and angle of that screen would have been impossible to read through glare.. I can't even read my temp...
Lol... KK the sketchup model probably won't be high enough quality for a 3ds max model. but you can use the original .obj model and import into...
That Forza model seems to cleanup up pretty nicely.. I've turned it into a sketchup model, so I'll tidy it up a bit and upload it onto Sketchup...
3d printing or injection molding out of china.. they do a lot of prototype components. The technology is too expensive in the west.
I thought this was interesting... the Forza model used a lot of components overlayed to make the body of the race 300zx... you can delete all...
thanks Arashi, one problem though, its not an anywhere near accurate 3d model of the fascia. I had a look, and its just a symmetrical...
Hello!
Separate names with a comma.