Hi All I did an Auto to Manual swap ages ago and car runs fine, Am doing some work to it now and wondered if I can remove the Auto ECU and will it...
condensation in the exhausts happens with all cars, and yeah the buzzing is the fuel pump
My metal bypass pipe has a small hole about 1mm in size had to change it out as it was spraying water under the cambelt cover and onto the top...
that is great many thanks for the info Terry am liking the car build as well
Have you got any more info on the LPG system would be interested to know more about the setup and parts used
you haven't plumbed your fuel lines in the wrong way round. from the fuel rail to the filter and the return to the tank have you. just a thought...
try some coil spring assisters cheap enough to buy and fit
Check the fuse you more likely shorted a wire and blew the fuse.
Beautiful work looking stunning
remove the plastic trims around the hatch and disconnect the wiring loom to the 3rd light. wiper window heater. the loom will then pull out of the...
mine did this on my car and kept sounding the horn even when parked, replaced the relay not done it since, think the heat helped to expand things...
what about a turbo bearing on the way out, giving intermitent squeaks. or could be the sound of pressure escaping from the rad cap
as a quick fix stick some bare wire between the terminal and the post, when you push the terminal on the wire takes up the looseness of the clamp...
I have on my zed TT front prop and NA rear, have removed it again as the vibrations were so bad, it needs balancing. would 100% recommend you get...
What thread is this then ?
could be to switch between different ecu maps, have a look where the wires run
my zed is auto also has a really bad vibration, does it through all gears and neutral but only when moving, i know 100% its my prop as its tt...
fast work good job gents
please disregard this found the page now is a fuel temp sensor circuit
what is code 42 please, cant find the link to the code listings
Separate names with a comma.
