@Jamie can probably pull some off a car for you
Could be upper clamps not tight.
Check the clamps are tight and then Pressure test it to check.
There is no valve in the hose, but the hose runs to a check valve and then to the brake booster. The check valve is closed when the manifold is...
Get moving on those bookings guys so we don't have to share with members of the public!
I'm also going to open it up for late model Z chassis,...
So it's a little while off but we're starting to get some things happening for ZedFest 2020. We're keen to make this a big one, and...
That looks great! Sorry to hear you didn’t end up using the LS coils -I believe the key to avoiding premature discharge is in not going overboard...
From what I can see of the location it looks like it... normally would have an odd looking fitting screwed into it that is the oil feed for the...
Only pipe threads I can think of in the block would be the water plugs at the front and the oil feed on the drivers side at the rear?
One for the data fiends.
Either a wiring fault or an fuel injector fault.
Why did you replace it previously? Was it a new fuel injector? Were any tests carried out...
If you have spark on that cylinder then the problem is not the PTU.
You also need fuel and compression to fire.
Put a screwdriver on the...
New never fit pair of Ezzupturbo bonnet struts. Brackets are powder coated midnight blue.
Good opportunity for HICAS removal
A multi meter is too slow to catch a pulse signal.
If you want to bring it up Hornsby way I’m pretty confident I could a diagnosis for you.
If you are missing spark the PTU is a possibility. If you have a logic probe you can test pulse signal to verify.
Where are you located?
Set of six fuel injectors. Have been ultrasonic cleaned, flow tested, and fit with new Pintle caps.
Can supply new viton o rings for an...
No probs and yes it would
Instructions are all available via the ad I linked to.
Did some reading on tt.net.
The pinion axle is offset on the TT sensor, which allows the the two sensors to be interchangeable despite the two...
Separate names with a comma.