Purely asthetic, either you like the look of a single or twin. You would want at least 3.5 inch single system to match a twin 2.5 system.
Wouldn't it be cheaper to buy new pistons than getting the block sleeved?
There are a few pads on that circuit board that could do with resoldering.
Might take a bit of searching (unless it's in the tech section) but someone used a repair kit (think it might have been for a patrol).
I modified 2.5" cats into 3" in 2.5" out cats. My cats are further back than yours (in stock location), so have more clearance and sit up higher....
Didn't have to do anything but we replaced the flanges with vbands on both sides. That was just because I prefer vbands to flanges. We also cut up...
We cut the turbo flange off the driver's dump pipe, welded 15-20 mm of stainless pipe (2 sizes) to the flange and then welded the rest of the dump...
We cut the flange off my driver's dump and add about 15-20 mm of each pipe
The only real issue is that they're designed for left hand drive zeds, so they are usually very close to the steering shaft on RHD zeds. Made a...
Dumps are good but you will probably have to do some clearancing around the steering shaft.
Good luck.
What is the condition of your existing mounting kit? Can you reuse your existing?
Even better when you make your alarm system fold the mirrors when the zed is locked.
Easiest way might be to remove the mongoose and replace with a new system. Otherwise you could try replacing relays in your mongoose or checking...
Most likely an issue aftermarket alarm system.
Sorry Rob, we can't make it. Hope it's a great day.
What about the earliest imported JDM Z32? My GCZ32 was imported and complianced in 1993.
Have a good read of the nistune documents on their website. You should be able to use the short and long trims at 2000 rpm to work out if your...
They'd be a good choice, still OEM if not exactly correct and they suit your new zed.
Your master cylinder is most likely pitted causing the leak past the seals. If you want to rebuild it then getting it sleeved would be best. For...
Separate names with a comma.
