What offset do you have? I'm looking at getting new rims to fit a 305 rear, thinking about 40mm offset would work.
What did you do for your clutch master cyliner? where it hits the RH head?
Hi NS-Zed & Woo05H, I'm part way through mine, using an L77 6.0L with T6060. All LS accessories. Fabing all my own mounts etc. I just started a...
Hi Ivan, the front of the trans tunnel needs to be panel beaten about 20mm. I'm using the T6060 gearbox. Less if you use a Nissan 5spd, good info...
L77 6.0L Fits nicely[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
For all your plastic trim your far better off just repainting it all with a good plastic paint. I did my whole interior including the dash and and...
Nice clean up. How are the valve guides? If they are worn that could cause your valve stem seals to wear prematurely.
Don't know what the Z1 hose (not cable) cost but that cost me $56, all Speedflow fittings and hose bought from Couplers Perth. Its for an...
Are you selling the clear front indicators?
The 1995 model did not have a factory boost gauge and had an air bag fitted steering wheel, which yours dose not.
Recovered interior panels over the weekend. Grey microfibre cloth and black leather on the centre cover. -3 Stainless steel braided clutch line....
I agree with Stu and Martin. Journal bearing turbos are sealed with steel rings that look like piston rings. They are not at perfect seal and work...
Joseph, sounds like your really confused. You say "in N or P it revs fine no issues but once you put it into a gear it’s seems like it’s...
Overly complicated, story of the whole car. Thanks for the reply, well explained.
Just interested how deleting HICAS and fitting a lock out effects the Z32 handling.
[IMG] The same happened to mine a while back. If you can get into the black connector box its usually a terminal on the circuit board that has...
Any progress? Where are you?
After 4 years of not driving, no oil in the top of the engine the valve stem seals will be dry and hard. Definitely change your oil and then try a...
Well done sorting it out Scott, was this the red car? As you well know nothing comes easy on these cars. Also most of the answers can thankfully...
Yes you need to replace the VTC gears. PS. The outer springs have nothing to do with the vtc rattle, this is a common misconception and replacing...
Separate names with a comma.
