Hey mate, i read in your post that you get some work done by a local mechanic. Just wondering who he is? When i rebuilt my engine i couldn't find...
Hi all, ive got a leak coming from what ive found out is my power steering rack pressure control flow valve solenoid. One of these things-...
Rgs Performance is in Australia
Pm sent - grommet
Oh well, i haven't seen it before and I thought it was funny :)
Spotted this one on RBT on tv tonight, a homemade wooden spoiler :) photos wouldnt post for me but these should -...
Thanks mate, charcoal canister isnt there anymore so ill just cap it off for now until I can get down there and pull it out
Can someone please tell me what this little hard line is please? It starts at the front LH side of the engine bay below the fuse box and runs...
Can someone please tell me the inside diameter of the front crankcase breather hoses, and the brake and clutch booster hoses?
Google has a few too
Not a bad idea, ill give it a go
I lubed it up with grease and oil, just think the hose is too good for it - thick and no stretch
Didnt think it would, I might have to try push it down a bit further anyway tho, to give the clamp a good grip on the inlet :(
I replaced the hoses on my oil cooler but could only push the restrictor in the new hose about 1.5 cm. Would this matter if i just just plugged it...
Or maybe Karl(90ttz) @ Epic Automotive
I found that too, Ive bought t-bolt clamps before but ended up going back to the other ones. T-bolt ones looked cooler tho :cool:
They used to be a bit noisy sometimes, i could hear the air going through them at boost so i didnt use them much. And more spots for boost leaks
They needed a little trimming too :( I got some see how they were cos im missing 1 of the pipes I was using but might just use the hard pipes for now.
Separate names with a comma.