For Sale TT Clutch Master cylinder / Slave cylinder & Custom made SS braided clutch line (used)

Discussion in 'Car Parts for Sale or Wanted' started by zx299, Oct 18, 2019.

Thread Status:
Not open for further replies.
  1. zx299

    zx299 Well-Known Member

    [​IMG]

    [​IMG]

    I had these on my zed for about 15k kms and replaced them when I rebuilt my motor (even though there was nothing wrong with them). I've had the whole system (filled with clutch fluid to protect the seals) in storage.

    The custom made Stainless Steel braided clutch line joins the Master and Slave cylinder directly, making clutch bleeding a 5 minute job by eliminating all that oem 'garbage' plumbing on your firewall and inner guard. This was one of the best mods I ever did on the zed :cool:

    The SS line cost me $120 to have made up but I'm selling the whole lot (master/slave/ss braided line) for $79 ..... a great opportunity to grab a cheap Clutch line upgrade and replace your ageing Master and Slave cylinders

    Pm me for details or if you have any questions
     
  2. zx299

    zx299 Well-Known Member

    I replaced all of these at the same time when my Slave dropped it's lunch. The Master cylinder is a Genuine Nissan part and the Slave cylinder is aftermarket because oem Slave cylinders were not available at the time
     
  3. zx299

    zx299 Well-Known Member

    FREE postage ($11.55 Postpak) for quick sale

    These were over $350 but they're just collecting dust in the cupboard, so I'm prepared to throw in free postage to see them put to good use by somebody

    If you've had the same Master / Slave cylinder in your ttz for years, you're probably long overdue for a swap .... this setup is an easy fit and it will be the fastest clutch bleed you've ever done on the zed in your life :cool:
     
  4. my300zx

    my300zx New Member

    where are you located
     
  5. zx299

    zx299 Well-Known Member

    SOLD
     
Thread Status:
Not open for further replies.

Share This Page