I have a set of used stock cams out of my TT manual VG
$50 for the set- Nothing wrong with them- they came out of a working motor
Would you consider sending to Brisbane?
(me paying postage of course)
SOLD- Thanks Colin- Enjoy mate
Sold pending payment from Col
Cleaning out my shed
These AMS kits were great but ran with the z1 kit instead
Postage at buyers expense
Prices don't include shipping
Cleaning out the shed to make room
All prices don't include shipping
Postage available at buyers expense
Shipping from 4113 QLD
2860s were bored to 2971 on the front and rear housings through the turbo specialist
If I was to go 3071, that's when outside...
I'll share the results fella's
Should be a few weeks before done, then the waiting game again to dyno day
For those that are following this thread, I found a Turbo place in Molendainar (Gold Coast) that machines turbos to custom...
Will keep it in mind
Waiting to hear back about sizes of the 2967
Thanks Chrispy,beaver and magic Mike
I shall look into getting diameter of the front housings but sounds promising
At 1st glance
Recently i blew the bearings in passenger side GT2860 running 25psi
I was hoping to get to 30psi but the twin gt2860 setup started losing boost...
Separate names with a comma.