What have you done to your zed today? Part 4............

Discussion in 'Non Technical' started by Vader, Jun 17, 2014.

  1. Anti

    Anti 14.7 x 14.7 = 44.1

    That's pretty cool man. Shame about putting the weight so far back past the axle but a great outcome nevertheless

    Put some bulkhead terminals behind the rear center boot trim panel as a jump point
     
  2. Instamatic

    Instamatic Active Member

    Snug fit, but I'd be a little concerned about getting rear-ended. Pushing a battery into a fuel tank might have... undesirable consequences.
     
  3. Jinxed

    Jinxed Moderator

    im going to assume that you consider the car exploding to be a bad thing?

    if its behind the reo bar, then it is "kinda" protected
     
  4. rollin

    rollin First 9

    strong possibilty of a major electrical sort at teh least, but i guess some cars have their battery mounted quite forward in the engine bay

    I think the install is neat, location a bit odd though
     
  5. QLDZDR

    QLDZDR ID=David

    My 2+2 was rear ended by the rear end of a Pajero a couple of weeks ago.
    His towbar ball hit that exact spot. Crushed the number plate.

    Footage captured on the rear view internal camera. The number plate mounted camera doesn't work anymore.
     
  6. kickerzx

    kickerzx Member

    [​IMG]

    Was a long haul to get the damn thing in house. But got it today, spent a few hours in the garage and hey presto.
    Step two: Check :D
     
  7. 92z32tt

    92z32tt New Member

    What is it? :confused::eek:
     
  8. kickerzx

    kickerzx Member

    Drive by wire motor :)
     
  9. MagicMike

    MagicMike Moderator Staff Member

    Why did you convert? I can only assume some kind of ECU feedback/control/protection, and being able to cut throttle?
     
  10. NI85

    NI85 Active Member

    Added extra lighting to my car. Today finished the side bumper reflectors to light up. The other week I added the parker lights to the after-market side blinker unit and reconnected the "fog" light wire back to where it should be.

    End result.
    [​IMG]
     
  11. SRB-2NV

    SRB-2NV #TEAMROB

    Drove mine a few days ago, need to go over all the piping for boost leaks and then its getting towed to UAS for the front brakes, front suspension and dump pipes to be installed. Then i'll book the car in for paint and fit the TwinZ gear to it. Its getting real close :D
     
  12. TQE-756

    TQE-756 Active Member

    Engine Swap a la' _Robbo_

    Thanks to the incredible generosity and mechanical talent of Dan, we swapped my engine out!
    It's funny how this came about, I had oil in my coolant and was considering parting her out and had made the decision after 3 weeks of depression, then ZXGirl turns up in my front yard and offers to buy it even after I explained what was happening to the engine (had already had the heads done). Anyway she didn't end up buying her and it strengthened my resolve to fix it back up and the same day I noticed Dan's (_Robbo_) engine for sale!! :D :D
    His had only done 160 thousand odd K's compared to my 414 Thousand and was on the forum for $700... so I grabbed it and a couple of weeks ago in a quiet factory in Frankenstein we put it in...

    [img=http://s33.postimg.org/4g55ynh9n/Strapped_up.jpg]

    [img=http://s33.postimg.org/800afxyqz/We_have_liftoff.jpg]

    [img=http://s33.postimg.org/t0wco9iy3/Enginebay_cleanup.jpg]

    [img=http://s33.postimg.org/c6by3sjl7/compulsary_look_what_we_did.jpg]

    Dan's Donor Engine... Hmmmm nice matching timing covers! :zlove:

    [img=http://s33.postimg.org/hteboo2sr/hmmm_nice_red_covers.jpg]

    [img=http://s33.postimg.org/6rwo6b8kr/ready_for_launch.jpg]

    The Master himself! lol!

    [img=http://s33.postimg.org/l8oiymnfv/Obi_Wan_Kenobi.jpg]

    [img=http://s33.postimg.org/6ma2uaqsr/final_approach.jpg]

    [img=http://s33.postimg.org/tzmd1erzf/Landed.jpg]

    Dan, I can't thank you enough mate! For someone still in his 20's you showed mechanical patience and dogged persaverance of someone much older.
    Thanks for your generousity of time and the extra bits you threw in for a tiny bit extra (and I mean tiny)!
    Job well done mate! :thumbup:
     
  13. Madcow

    Madcow Active Member

    Drove to CRD in the rain collected my car and took it home.
     
  14. Mitch

    Mitch Has one gear: GO

    Sick of getting a flat battery after extended periods of rest. At most I drive the Z twice a month... Added this which should solve the flat battery problem nicely.

    [​IMG]

    Only recommendation is that the green disconnect knob is too tall and impacts the bonnet when the hood is down. This means that when you think it's disconnected, when you close the bonnet it re-connects.
    Easy solution is to remove the green nut entirely for tool-free battery disconnect.

    Had one of these that I could have used, but space is at a premium, so left it in the parts cupboard...
    [​IMG]
     
  15. TQE-756

    TQE-756 Active Member

    Changed my Gearbox Oil...

    Thanks once again to Dan (_Robbo_) for "saving" my Zed.... got inspired after the engine swap to start doing all my own work on the Zed again and had a slight whine in the gearbox when cold so i went out and bought myself a handpump (Tomthumb) and some Penrite 70w-90 and did the job. Made heeeaaps of difference and the gear changes are silky smooth once again!
    :zlove:
     
  16. kickerzx

    kickerzx Member

    Got past me..
    Yes all of the above. Power limiter is one big reason. I can have 3 different DBW tables with individual offset tables on them all.. Powerfull stuff.
    Works perfectly.
     
  17. tassuperkart

    tassuperkart Its a lie I tell you!

    Additionally, for serious wank factor, invoke some "anti-lag' above "X" rpm for that flames/banging fun factor!!!!
    Easy to do.
    Another nice toy is to invoke liftoff with no throttle. Hillstartsd are a breeze now via throttle/brake rather than heavfing on a handbrake.!

    E
     
  18. kickerzx

    kickerzx Member

    Yeah. And throttleblip on dowshift. I can use it for idlecontrol too. Also i can tune throttle for best power. It isnt always wide open throttle that gives best VE. Sometimes air velocity meens more than air availability. Lots of possibilities..
     
  19. Purchased Brand new 370z Akebono Calipers. Had to be purchased after feeling the stopping power they can unleash in Luke300's car.
     
  20. timothyds

    timothyds Member

    i have these and while i have nothing to compare to i think they are awesome just dont put your phone on the passenger seat as it will hit the dash and smash :(. never mind i needed a new one anyway.
     

Share This Page